Start with the symptom
Stains, smells, taste, pressure — the water tells you where to look. Each
diagnosis page reads the symptom, names the likely causes, and says exactly
which test settles it before you spend anything on equipment.
Diagnose
Guides
- The Anode Rod: The Part That Corrodes So Your Tank Doesn't
- Fixing Acidic Well Water: The Neutralizer, Its Trade-Off, and Its Refills
- Filtering Chlorine Taste on City Water: Carbon, Scope, and the Chloramine Catch
- Iron in Well Water: Confirm It, Then Match the Treatment
- Well Pump Won't Shut Off: The Gauge Test Settles It
- Water Test Kits: Strips, Dedicated Kits, or Mail-In Lab — Which Tier
- Choosing a Reverse Osmosis System: Tank, Tankless, or Remineralizing
- Well Pump Short Cycling: The Pressure Tank Is the First Suspect
- Signs a Septic System Is Failing, Per EPA
- Sediment Filters for Well Water: Read the Micron Ladder, Not the Box
- Septic Lifespan and Maintenance: EPA's Numbers
- Water Softener vs Salt-Free: One Removes Hardness, One Doesn't
- Sump Backup on a Well: Battery or Water-Powered
- Treating Rotten-Egg Water: Match the Fix to the Source and the Number
- Well Water Testing: What to Test, When, and What the Results Decide
- Well Water Treatment Systems: Build the Train From Your Test
- How a Well System Survives Winter: Below the Frost Line
What's in the water
- Acidity (low pH) — Water below EPA's aesthetic pH range of 6.5 to 8.5 is corrosive — it attacks metal plumbing, causes bitter metallic taste, and is the usual cause of blue-green copper staining.
- Copper — Copper in tap water almost always comes from the home's own pipes corroding, not the well. Above the EPA secondary standard it causes metallic taste and the characteristic blue-green staining.
- Entrained air — Microscopic air bubbles released when pressurized water reaches the open tap. The glass test settles it in minutes - air clears from the bottom up and is harmless to health, plumbing and appliances.
- Chlorine and chloramine — The disinfectants your utility adds on purpose. CDC puts acceptable residual levels at up to 4 mg/L. Chlorine off-gasses from a standing glass; chloramine persists - which is both the diagnostic and the reason their removal differs.
- Iron — Dissolved or particulate iron in groundwater. Above the EPA secondary standard it causes rusty color, sediment, metallic taste and reddish-orange staining on fixtures and laundry.
- Manganese — A metal that often occurs alongside iron in groundwater. Above the EPA secondary standard it causes black-to-brown color, black staining and a bitter metallic taste.
- Hardness (calcium and magnesium) — Dissolved calcium and magnesium. Heated, they precipitate as scale in pipes, water heaters and appliances; in the sink they make soap scum and spotting. USGS classifies water harder than 180 mg/L as CaCO3 as very hard.
- Hydrogen sulfide — The gas behind the rotten-egg taste and odor in well water — produced by soil and rock chemistry, by sulfur bacteria in the well or plumbing, or inside the water heater itself. Also leaves black stains on silverware and fixtures.
- Sediment and turbidity — Suspended particles — clay, silt, fine organic and inorganic matter — that make water hazy. Measured in NTU. Settles or persists in a standing glass, unlike entrained air, which clears from the bottom up.
- Tannins — Natural organics from decomposing vegetation that tint water a tea color. Distinguished from iron by a standing glass — tannin color stays uniform, iron particles settle. Treatment choice hinges on the water's pH.
- Iron bacteria — Living organisms that combine iron or manganese with oxygen into rust deposits and sticky slime on pipes, pumps, and fixtures - not known to cause disease, per MDH, but capable of clogging wells and sheltering organisms that do.
- Chloride (and its sodium companion) — The salty-taste ion, with EPA's 250 mg/L secondary standard - naturally occurring, but elevated levels point at road salt, fertilizer, sewage, a softener, or coastal intrusion, and both ions accelerate corrosion.