Stains, smells, taste, pressure — the water tells you where to look. Each
diagnosis page reads the symptom, names the likely causes, and says exactly
which test settles it before you spend anything on equipment.
Chloride (and its sodium companion)— The salty-taste ion, with EPA's 250 mg/L secondary standard - naturally occurring, but elevated levels point at road salt, fertilizer, sewage, a softener, or coastal intrusion, and both ions accelerate corrosion.
Chlorine and chloramine— The disinfectants your utility adds on purpose. CDC puts acceptable residual levels at up to 4 mg/L. Chlorine off-gasses from a standing glass; chloramine persists - which is both the diagnostic and the reason their removal differs.
Hardness (calcium and magnesium)— Dissolved calcium and magnesium. Heated, they precipitate as scale in pipes, water heaters and appliances; in the sink they make soap scum and spotting. USGS classifies water harder than 180 mg/L as CaCO3 as very hard.
Acidity (low pH)— Water below EPA's aesthetic pH range of 6.5 to 8.5 is corrosive — it attacks metal plumbing, causes bitter metallic taste, and is the usual cause of blue-green copper staining.
Entrained air— Microscopic air bubbles released when pressurized water reaches the open tap. The glass test settles it in minutes - air clears from the bottom up and is harmless to health, plumbing and appliances.
Copper— Copper in tap water almost always comes from the home's own pipes corroding, not the well. Above the EPA secondary standard it causes metallic taste and the characteristic blue-green staining.
Hydrogen sulfide— The gas behind the rotten-egg taste and odor in well water — produced by soil and rock chemistry, by sulfur bacteria in the well or plumbing, or inside the water heater itself. Also leaves black stains on silverware and fixtures.
Iron bacteria— Living organisms that combine iron or manganese with oxygen into rust deposits and sticky slime on pipes, pumps, and fixtures - not known to cause disease, per MDH, but capable of clogging wells and sheltering organisms that do.
Iron— Dissolved or particulate iron in groundwater. Above the EPA secondary standard it causes rusty color, sediment, metallic taste and reddish-orange staining on fixtures and laundry.
Manganese— A metal that often occurs alongside iron in groundwater. Above the EPA secondary standard it causes black-to-brown color, black staining and a bitter metallic taste.
Sediment and turbidity— Suspended particles — clay, silt, fine organic and inorganic matter — that make water hazy. Measured in NTU. Settles or persists in a standing glass, unlike entrained air, which clears from the bottom up.
Tannins— Natural organics from decomposing vegetation that tint water a tea color. Distinguished from iron by a standing glass — tannin color stays uniform, iron particles settle. Treatment choice hinges on the water's pH.